TEL FAX

06-6378-6115 06-6378-6117

http://www.viswill.jp		Japanese  English  Korean
Top Page				Access Map
Appearance Inspection System	Information Request	Inquiry	Our Business	Site Map

Our non-vibratory parts feeder, which eliminates the need for a vibratory feeder, imposes no loading on products, hence there is no damage. Products never clog up during transport. Continuous operation for extended periods of time is readily attainable and vulnerable products can be transported without damage.

Appearance Inspection Systems	Tablet High-End	Tablet Low-End	Capsule	Granule
Vial	Rubber Stopper	Chip Area Sensor	Non-vibratory parts feeder

Specification
Applicable   chips	Chip Monolithic Ceramic Capacitors、Tantalum Capacitors、Array Chip、 Chip Impedance、Ceramic Resonators、Film Condenser、 Chip Led、Chip Coil、etc
Applicable Size	Less than 20 mm (Height : less than 0.2mm)
Processing Capacity	8,000 pcs／min. in maximum (for 0201 size ceramic capacitors)
Hopper	Capacity : 0.8 litter Material : Stainless steal
Feeder	Straight conveyor Brushless DC motor
Flow Control Turntable	φ450、φ300、φ150　※ Depending on Chip size Brushless DC motor Adjusting guide (Width, height, alignment) Air blow for removal of bad alignment, Detection sensor for staying objects Jam recovoery system
Power Source	DC24V
Power consumption	110VA
Air Source	0.01〜0.05MPa
Environmental   Condition	Temperature: 10〜30℃, Humidity; 40〜70%

Appearance Inspection System	Information Request	Inquiry	Our Business	Site Map
Top Page				Access Map
Copyright (C) 2009 DAIICHI JITSUGYO VISWILL CO., LTD . All Rights Reserved